User's Manual

VCU Unit Installation and Provisioning
LTE 700 MHz MobileAccessVE Instant Coverage Solution User Manual 29
Type the unit name in the Controller Name dialog and click OK. Note: Up to 17 alpha-
numeric characters are allowed.
4.4.3 Setting RF Parameters
In a Master-Slave mode (multi-tier architecture) the RF parameters are only configured for the
Master VCU unit.
Set the RF parameters according to the LTE Signal Source transmission configuration (MIMO or
SISO). Each type of configuration is defined through a dedicated tab.
This section describes the MIMO and the SISO configuration procedures.
To Configure the MIMO RF Parameters:
1. Select the Master VCU in the topology tree and then select the RF Parameters tab. Verify
that the Service Mode parameter is defined as MIMO.