User's Manual

Overview
LTE 700 MHz MobileAccessVE Instant Coverage Solution User Manual 5
Table 1: VCU Ports Description
Ports
Description
MIMO1
MIMO2
RF connections (two TDD MIMO channels) to the service provider LTE
Signal Source equipment. N-Type female connectors. Coax cables.
Note: When supporting SISO service – only MIMO 1 connector is relevant.
Management
RJ45 web management connection.
VE Access Pod
Ports 1-12
VAP/VCU port connections.
For Master VCU – Connections to Slave VCUs or VAPs.
For Slave VCU – Connections to VAPs.
Ethernet Ports
1-12
Relevant only for Slave VCUs. Ethernet switch connections.
Master
Used for connecting a Slave VCU to the Master VCU in a multi-tier
deployment. Connects to one of the VAP ports of the Master VCU.
Reset
N/A in current version.
The following provides a description of the front panel LEDs.
Table 2: VCU LEDs Description
LED
Description
PWR
Indicates whether the VCU receives power:
Green - Power OK
Disabled - No power received by VCU
ACT
VCU activity LED:
Solid Green – During initialization
Blinking Green – Normal system operation
Fast Blinking Green – User activated
VCU Identify on this VCU
VAP Status (One LED
per Port)
Indicates the status of the corresponding unit (VAP or VCU):
Blinking Green – Unit is initializing
Solid Green – Normal operation of unit
Solid Orange – Unit is faulty, or unmanaged. This can be due to
mismatch type, VoIP phone, etc.
Fast Blinking Green – User invoked “Identify” command on the unit
Off – No VAP or VCU connected to this port.
MIMO (One LED per
Channel)
Indicates the status of connected RF capacity source:
Green – Master VCU only. Normal RF level
Orange – Master VCU only. RF level is either too low, too
high, or service has been turned off by the user.
Off – VCU is Slave.
Master
Indicates the status of the connection to the Master VCU:
Off – Master mode (not connected to VCU)
Blinking Green – During Attachment process with Master VCU
Solid green – Slave (IF-IF) mode and connected to Master
PWR LED
ACT LED
VAP (1-12) Status LEDs
Master LED
MIMO1
LED
MIMO2
LED