User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Preface Material
List of Acronyms
802.11a WLAN IEEE Standard for 5GHz ISM band
802.11b/g WLAN IEEE Standard for 2.4GHz ISM band
AGC Automatic Gain Control
AP Access Point
ARM Adaptive Radio Management
BDA Bi-Directional Amplifier
BU Base Unit
DFS Dynamic Frequency Selection
DL Downlink
ETL Electrical Safety Testing Organization
FCC Federal Communications Commission
GUI Graphical User Interface
HTTP Hypertext Transfer Protocol
IEEE Institute of Electrical and Electronic Engineering
IP Internet Protocol Address
LBS Location Based Services
LWAPP Light Weight Access Point Protocol
LED Light Emission Diode
PSU Power Supply Unit
RHU Remote Hub Unit
RP Reverse polarity
RRM Remote Radio Management
RTLS Real Time Location Systems
SCU Splitting and Combining Unit
SMA A coaxial connector (Subminiture Version A)
SNMP Simple Network Management Protocol
SNR Signal to Noise Ratio
TNC (Threaded Neill-concelman) Connector
Type-N Threaded RF type N connector for coaxial cable
UL Uplink
VoIP Voice over Internet Protocol
WCE WiFi Coverage Expander
WiFi Interoperability of WLAN products based on the IEEE 802.11 standards
WLAN Wireless Local Area Network
MA-860 Installation and Configuration Guide
IX