User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Appendix
Figure 6-4.Automatic IP Discovery Settings Window
5. Enable the following checkboxes: DHCP, BOOTP, Auto-IP and Clear Gateway.
6.. Click Next. The Assignment window appears.
7. Click Assign to assign the MA860 unit the defined parameters. Once the parameters have
been assigned, the message ‘Completed Successfully’ appears and the Finish button is
enabled.
Figure 6-5. Finish Static IP Address Definition
8. Click Finish. The Device Installer Main window reappears and the installed unit will be
listed in the window.
MA-860 Installation and Configuration Guide 61