User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Appendix
6.2 Using the Lantronix Device Installer
NOTE: Be sure the installed version is 3.6 or higher.
6.2.1 Installing and Navigating the Application
NOTE: Be sure the installed version is 4.1.0.3 or higher.
1. Install the Lantronix DeviceInstaller application on your computer and launch the
application. The DeviceInstaller Main window appears.
Figure 6-1. DeviceInstaller Main Window
2. In the toolbar, click Search to perform auto-discovery. The currently connected MA 860
units in the network will be identified and listed in the window according to:
• Type - communication hardware version - XPort-03
• IP Address – currently defined IP address
• Hardware Address – MAC address
• Additional identification parameters may be available.
MA-860 Installation and Configuration Guide 59