User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Preface Material
Professional Installation of Transmitter
According to FCC 15.203, if an intentional radiator has a standard antenna connector, it must be
professionally installed according to FCC 15.203 regulations.
In addition, the following also demonstrates compliance with Section 15.204(d), (i):
1. The MA-860 cannot be sold to the general public. It is only marketed and sold by authorized agents.
Only professional installation qualified ("licensed") by MobileAccess for this purpose is allowed to
install the MA-860.
2. The installation must be controlled and follow the requirement of "Installation Manual"
(
P/N:709C002901
). Each potential installer must receive special training, which is a condition for
receiving the license from MobileAccess Inc to become a "licensed" installer. The installation
procedure as described in the "Installation Manual" includes the mechanical installation and initial
setup by a PC based tool.
3. The intended application of the system is exclusively for the commercial/industry use.
MA-860 Installation and Configuration Guide
VII