User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Appendix
Table 6-1. MA-860 Engineering Tool Window Parameter Descriptions
Window Item Description
DC Used to show and configure status of voltage at each antenna port.
Voltage is automatically disabled (Off) to a port where an antenna was not detected
during auto-discovery (upon power-up and upon command from the user).
The button adjacent to each DC field is used to manually disable or enable voltage to
the corresponding antenna (relevant for service personnel under conditions where an
antenna is disconnected or replaced).
Adj a/bg Used to perform cable adjustment for 802.11a and 802.11/bg services.
Note: this is a required configuration procedure.
The color of the buttons indicate the status of the corresponding adjustment
procedure:
Black – adjustment not initiated or communication error during the adjustment.
Yellow – adjustment in process
Green – successful adjustment
Red – failed adjustment
Antenna Power Power supplied to the antenna
AP Power AP1..4 .11a – shows the 802.11a service power provided by the corresponding (1 to
4) AP.
Note: During normal operation, this value should be equal to the power
transmitted by the relevant antenna (parameter Pwr 11.a of the corresponding
antenna*).
MA-860 Installation and Configuration Guide 57