User Manual

Power-up and Provisioning the Unit
NOTE: If OFF is displayed, it indicates that there is no power or that the WCE was not
detected.
3. Perform 802.11a cable adjustments as follows:
• Set the AP power to 20dBm.
• Click the corresponding Adj a button. The adjustment status will be indicated by the
color of the button:
BLACK – not adjusted or waiting for connection. Try again.
YELLOW – adjustment in process.
GREEN – successful adjustment.
RED – adjustment failure. Try again.
• Repeat for each link (i.e. four times).
• For each channel, verify that AP1..4 Pwr is equal to Ant1..4 Pwr.
4. Perform cable adjustments for 802.11bg as follows:
• Set the AP power to 20dBm.
• Click the corresponding Adj bg. The adjustment status will be indicated by the color of
the button as detailed in the previous step.
• Repeat for each link (i.e. four times).
• For each channel, verify that AP1..4 Pwr is equal to Ant1..4 Pwr.
5.9
5. Click the Alarms tab. Referring to the following section (
):
• Under Traps Select, uncheck (filter out) irrelevant alarms (where antennas or APs are
not connected).
• Verify that the connected Access Point and antenna indicators are Green.
• Verify that the calibration indicators are Green.
MA-860 Installation and Configuration Guide 55