User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Power-up and Provisioning the Unit
5.10.2 Provisioning Procedure
Notes:
1. The provisioning procedure is NOT required by default since the unit is supplied with AGC
enabled and the provisioning procedure is performed automatically. This provisioning procedure
is only required only if AGC is disabled (by MobileAccess service personnel).
2. Refer to
6.1 and Table
6-1 for the locations and descriptions of the parameters described in
this section.
To provision the unit
1. Select the Adjustment tab. The following window appears.
Step 5.
Calibrate bg.
Step 4. Click a
Step 3. ON
Step 2. Click to
discover connected
antennas
Step 1 Invoke
Adjustment tab
Step 6. Review
Alarms
NOTE: The Full Discovery button checks for each and every antenna. During Full
Discovery, the unit DOES NOT transmit or receive data. To discover changes from the last
Discovery, click the Partial Discovery button. Partial Discovery does not affect the unit
output.
2. In the DC field of each channel to which an antenna is connected, verify that the DC
parameter is ON.
MA-860 Installation and Configuration Guide 54