User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Power-up and Provisioning the Unit
5.10 Provisioning via the MA-860 Engineering Tool
This procedure is performed via a local connection to a computer running the MA-860
Engineering Tool application.
5.10.1 Opening a Session to the Unit
To provision the MA-860 control unit using the Configuration Tool
1. Install the MA-860 MA Engineering Tool application on your computer.
2. Connect to the MA-860 front panel Local connector using the RS232 9-pin cable provided
with the MA-860 unit.
RS232
Computer running MA-860
Configuration Tool
MA-860 Installation and Configuration Guide 51