User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Power-up and Provisioning the Unit
4. Perform cable adjustments for 802.11bg as follows:
• Configure the AP for 20dBm output power (or Constant Power configuration).
• Click the corresponding Adj bg. Click the corresponding Adj a button. Verify that the
AP PWR and Ant PWR values of the corresponding channel are EQUAL.
• Repeat for each link (i.e. four times).
• For each channel, verify that AP1..4 Pwr is equal to Ant1..4 Pwr.
5. Click Apply to save adjustment and to save any changes in the DC settings
of the ports.
6. Validate that the AP output power level is equal WCE output power level.
5.8 What next?
After performing the adjustment procedure:
Click the Alarms tab. Referring to the following section ( 5.9) do the following:
• Disable (filter out) irrelevant alarms (where antennas or APs are not connected).
• Verify that the connected Access Point and antenna indicators are Green.
• Verify that the calibration indicators are Green.
MA-860 Installation and Configuration Guide 48