User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Power-up and Provisioning the Unit
3. Select the User (Oper or Field Eng) where Field Eng has configuration
privileges. Enter the password (see
5.3.)
4. Click Login. ()
The Main configuration window appears. The Main window is described in the following
section.
5.4.1 MA 860 View
Upon login, the MA-860 View shows the General tab that provides general information on the
MA860 unit and on the WCE connections on each channle.
NOTE: The display is refreshed automatically; however, if necessary, click the same tab again
(do not use the Web Browser Refresh option).
Note that there are six tab – three tabs on the upper window area and three in the lower
window area.
Table 5-1.
Multi-service
antenna units
Unit Identification
info
T
ab options
T
ab options
Figure 5-2. Main Window
MA-860 Installation and Configuration Guide 44