User Manual

Power-up and Provisioning the Unit
8. You will be are prompted to set the
Gateway, Netmask, telnet Config password and to
Change the DHCP device name.
IP Address : (000) .(000) .(000) .(000)
Set Gateway IP Address (Y) ?
Gateway IP Address : (192) .(168) .(010) .(245)
Netmask: Number of Bits for Host Part (0=default) (16)
Change telnet config password (N) ?
Change DHCP device name (not set) ? (N) ?
9. Press Enter to run through the rest of the parameters. When the Setup Menu is displayed
again, select 9 – Save and Exit.
5.2.1.3 Setting SNMP Parameters
1. Click the Windows Start option, choose Run and type Telnet and press Enter.
2. At the prompt Microsoft Telnet> o xxxx.xxxx.xxxx.xxxx 9999 (where xxxx.. is the IP address
of the unit). Press Enter.
3. Click OK and immediately press Enter to go into Setup Mode. The current settings will be
displayed, followed by the Change Setup menu.
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 SNMP configuration
8 exit without save
9 save and exit Your choice 3
4. Enter 3 (SNMP Configuration).
5. Set the SNMP Read and Write community names and the SNMP traps destination addresses
(up to three addresses can be defined).
SNMP community name for read (): public
SNMP community name for write (): private
Enter IP addresses for SNMP traps:
1: (000) 192.(000) 168.(000) 10.(000) 22
2: (000) .(000) .(000) .(000)
3: (000) .(000) .(000) .(000)
6. Press Enter to run through the rest of the parameters. When the Setup Menu is displayed
again, select 9 – Save and Exit.
MA-860 Installation and Configuration Guide 42