User Manual

Power-up and Provisioning the Unit
5.2 System Setup Configuration
Before deploying the device in the field, it is recommended that all system level configurations
are configured on the 860 WLAN module as defined in section 5.2
5.2.1.1 Assigning Network Parameters
The unit is factory set with the following static IP address:
IP address: 192.168.1.1
Subnet mask: 255.255.0.0
Default GW: 192.168.254.254
5.2.1.2• Change the static address using Telnet as described in section
Note: For networks with DHCP – refer to section
6.2.2
5.2.1.3• To set the SNMP parameters – refer to section .
5.2.1.2 Changing the Static IP Address
The static IP address is changed from the Telnet window.
To change the static IP address
1. Set your laptop IP to the same subnet as the static IP address assigned to the Repeater (e.g
192.168.1.2)
2. Connect the unit to your laptop with a cross cable.
3. Click the Windows Start option, choose Run and type Telnet and press Enter.
4. At the prompt Microsoft Telnet> o 192.168.1.1 9999. Press Enter.
5. Click OK and immediately press Enter to go into Setup Mode. The current settings will be
displayed, followed by the Change Setup menu.
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 SNMP configuration
8 exit without save
9 save and exit Your choice 0
6. Enter 0 (Server Configuration).
7. You will be prompted to change the IP address one byte at a time –Enter the new value for
each byte as you are prompted and press Enter. For example, the value entered below is
192.168.10.55
IP Address : (000) 192.(000) 168.(000) 10.(000) 55
MA-860 Installation and Configuration Guide 41