User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Installation
4.5.4 Add-on to an MA 2000 System
MA-860 may be integrated into the MA 2000 system using one of the following installations:
• Installing it directly on the MA 2000 RC top panel (using the supplied plate);
• Mounting it on a rack (using the supplied plate);
• Wall-mount near the MA 2000 cabinet.
NOTE: The coax outputs of the cabinet are connected to the appropriate ports on the MA-860
and the antennas are connected directly to the MA-860 module.
4.5.4.1 MA-860 RC 2000 Assembly
1. Assemble two side brackets to the plate sides as illustrated in Figure 4-5.
2. Assemble the MA-860 module to the supplied bracket using the four screws and washers as
illustrated below.
Side bracket
assembly
Connections to Remote
Cabinet antenna ports
Connections to
antennas
Side bracket
assembly
Figure 4-5. MA-860 Rack Installation
3. Assemble the plate to the MA 2000 RC by securing the brackets to the cabinet sides as
illustrated below.
MA-860 Installation and Configuration Guide 34