User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Installation
2. Mount the MA-860 and bracket assembly to the wall. When mounting, consider the
following:
• The type of screws used to mount the unit must suit the type of wall construction
(cement, bricks, etc.) so that the mount is secure.
• The position of the APs and required cable connections.
3. Assemble the MA 1000/1200 assembly to the MA-860 bracket.
4. For antenna sensing support (RHU 1000 version 3.1 and higher), connect between the
Control connectors at the rear of both units using cable 705102101.
NOTE: For antenna sensing support in RHU 1000 version 3.0 and lower, upgrade to a higher
version according to the MA 860 Upgrade Procedure Guide.
.
5. Connect the 802.11a/b/g Access Points to the corresponding ports on the MA-860 rear
panel.
Refer to section 1.3 for a description of the connections and distribution patterns.
NOTE: It is recommended to RESET the unit by removing and reinserting the power
connector on the front panel after connecting the APs.
6. Connect the network connection to the MA-860 rear panel network port.
NOTE 1: It is recommended to record the location of the units according to the MAC
addresses on the sticker at the rear of the units near the Ethernet port.
802.11b/g/a AP
connections
MA 1000 RHU
MA-860
MAC Address
Ethernet
connection
705102101 connector
MA-860 Installation and Configuration Guide 32