User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Installation
To assemble an RHU 1000 onto an MA 860
1. Assemble the supplied bracket to the top of the MA-860, where the notched side of the
bracket is towards the rear of the unit. Secure the bracket to the MA-860 unit using the four
supplied screws.
T
wo screws
T
wo screws
Figure 4-2. MA-860 and Bracket Assembly
2. Mount the MA-860 and bracket assembly to the wall. When mounting, consider the
following:
• The type of screws used to mount the unit must suit the type of wall construction
(cement, bricks, etc.) so that the mount is secure.
• The position of the APs and required cable connections.
3. Mount the MA 1000 RHU to the bracket using the four provided screws.
MA-860 Installation and Configuration Guide 28