User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Installation
4.3.3 In Line with Coax Cables
WCE’s light design enables connecting it between the two coax cables without additional
support.
NOTE: The bending moment for ½” coax cable = 3lbs per foot.
4.4 860 WLAN Module Installation
MA 860 can be mounted in the following configurations:
• Standalone – mounted directly on the wall with four screws
• Mounted onto an MA 1000 RHU
• Mount as add-on to an MA 1000 RHU with an MA 1200 add-on unit
• Add-on to a MA 2000 system
To install the unit
• Depending on your installation mount the unit on the IDF or telecom Closet wall (standalone
installation) or assemble it onto the MA system (when converged with other MA systems)
• Record location and serial number of MA860 unit
MA-860 Installation and Configuration Guide 24