User Manual
Table Of Contents
- 1 Introduction to the MA-860 System
- 1.1 About MobileAccess MA-860
- 1.2 System Architecture
- 1.3 Distribution of Services in the MA-860
- 1.4 Installation Configurations
- 1.5 Provisioning and Management
- 1.6 Installation and Configuration Workflow
- 2 Element Descriptions
- 3 Infrastructure Preparation
- 4 Installation
- 5 Power-up and Provisioning the Unit
- 6 Appendix
Installation
4.3 Wi-Fi Coverage Expander (WCE) Installation
Note: It is assumed the antennas have already been installed at the remote locations.
A WCE unit is installed near each antenna. The WCE can be installed in the following
configurations:
• Tie-Wrap / Wire-Tie to a fixture
• Wall Mounted – using four screws
• In-line with the coax cables
The WCE will be connected on one side to a 0.5'' low loss coaxial cable (typically running to a
remote wiring closet), and to the Passive Broadband Antenna usually through a jumper (flexible
1' coax cable). The following sections illustrate each type of WCE installation.
0.5'' low loss coaxial cable
Up to 250 ft
1' coax cable
MA-860 Installation and Configuration Guide 22