User's Manual

Element Descriptions
MA-860 Installation and Configuration Guide 14
2.2.2 WCE Mounting Support, Connections, and LEDs
The WCE provides the following Mounting Support Options, connection Ports, and LED indicators
Mounting Support and Interface Ports
The following table describes the rear panel ports.
Mounting/Ports Description
N-Type Male
Used to connect the WCE directly to the coax run from the IDF or
Telecom closet as indicated by the “To RHU” label.
N-Type Female
Used to connect any MobileAccess supported broadband
connection with a flexible N-Type – N-type Male Jumper cable
(typical 1’ length) as indicated by the “To Antenna” label.
Mounting Slots
Two mounting slots used to affix the unit to any available building
infrastructure via a wire-tie or tie-strap.
Mounting Holes
Four mounting holes that support any standard drywall screw
(3/16” in diameter).
WCE Status LEDs
The Status LEDs indicates the status and communication link between the 860 WLAN module
and WCE
LEDs Description
PWR ON – (normal) power supplied to the unit
Status Flickering – (normal) unit is operational