User's Manual

Appendix
MA-860 Installation and Configuration Guide 57
6
A
A
p
p
p
p
e
e
n
n
d
d
i
i
x
x
6.1 Adjustment Tab Parameters
This tab is used to:
• Configure the antennas manually and perform auto-discovery of antennas
• Perform cable adjustment for each channel
• View the power level at each antenna port and at each AP port
• Reset the MA-860 unit
Table 6-1. MA-860 Engineering Tool Window Parameter Descriptions
Window Item Description
DC Used to show and configure status of voltage at each antenna port.
Voltage is automatically disabled (Off) to a port where an antenna was not detected
during auto-discovery (upon power-up and upon command from the user).
The button adjacent to each DC field is used to manually disable or enable voltage to
the corresponding antenna (relevant for service personnel under conditions where an
antenna is disconnected or replaced).