User's Manual

Power-up and Provisioning the Unit
MA-860 Installation and Configuration Guide 55
• Set up a Constant Wave signal generator to 5.745GHz at 17dBm (for optimum
results).
Note: If the signal generator cannot be set to 17dBm, any level between 5 to 19 dBm
range will achieve good results.
• Click the corresponding Adj a button. The adjustment status will be indicated by the
color of the button:
BLACK – not adjusted or waiting for connection. Try again.
YELLOW – adjustment in process.
GREEN – successful adjustment.
RED – adjustment failure. Try again.
• Repeat for each link (i.e. four times).
• For each channel, verify that AP1..4 Pwr is equal to Ant1..4 Pwr.
4. Perform cable adjustments for 802.11bg as follows:
• Set up a Constant Wave signal generator to 2.447GHZ at 17dBm (for optimum
results).
Note: If the signal generator cannot be set to 17dBm, any level between 5 to 19 dBm
range will achieve good results.
• Click the corresponding Adj bg. The adjustment status will be indicated by the color of
the button:
BLACK – not adjusted or waiting for connection. Try again.
YELLOW – adjustment in process.
GREEN – successful adjustment.
RED – adjustment failure. Try again.
• Repeat for each link (i.e. four times).
• For each channel, verify that AP1..4 Pwr is equal to Ant1..4 Pwr.
5. Click the Alarms tab. Referring to the following section (
5.9):
• Under Traps Select, uncheck (filter out) irrelevant alarms (where antennas or APs are
not connected).
• Verify that the connected Access Point and antenna indicators are Green.
• Verify that the calibration indicators are Green.