User's Manual
Power-up and Provisioning the Unit
MA-860 Installation and Configuration Guide 54
5.10.2 Provisioning Procedure
Note: Refer to
6.1 and Table
6-1 for the locations and descriptions of the parameters described
in this section.
To provision the unit
1. Select the Adjustment tab. The following window appears.
NOTE: The Full Discovery button checks for each and every antenna. During Full
Discovery, the unit DOES NOT transmit or receive data. To discover changes from the last
Discovery, click the Partial Discovery button. Partial Discovery does not affect the unit
output.
2. In the DC field of each channel to which an antenna is connected, verify that the DC
parameter is ON.
NOTE: If OFF is displayed, it indicates the antenna is disconnected. If an alarm was
generated – the system disconnected the antenna due to a detected fault such as a short.
3. Perform 802.11a cable adjustments as follows:
Step 2. Click to
discover connected
antennas
Ste
p
3. ON
Ste
p
4. Click a
Ste
p
5.
Calibrate bg.
Step 6. Review
Alarms
Step 1 Invoke
Adjustment tab