User's Manual
Table Of Contents
- Preface Material
- Product Certifications
- Company Certification
- Introduction to the MA-860 System
- Element Descriptions
- Infrastructure Preparation
- Installation
- Power-up and Provisioning the Unit
- Appendix
Appendix
MA-860 Installation and Configuration Guide 55
4. Set the SNMP Read and Write community names and the SNMP traps destination addresses
(up to three addresses can be defined) by responding with Y to the prompt Set the
Gateway IP Address and defining the Address (as illustrated below).
SNMP community name for read (): public
SNMP community name for write (): private
Enter IP addresses for SNMP traps:
1: (000) 192.(000) 168.(000) 10.(000) 22
2: (000) .(000) .(000) .(000)
3: (000) .(000) .(000) .(000)
5. Press Enter to run through the rest of the parameters. When the Setup
Menu is displayed again, select 9 – Save and Exit.
6.1.3 Configuring Serial Parameters
This section describes how to verify and configure the serial communication parameters for each
MA 850A unit.
1. From the DeviceInstaller Main window, select the MA 850A unit to be configured and click
the Configure button the toolbar. The Configure Device dialog appears.
Figure 6-9. Current Serial Port Parameters