User's Manual
Table Of Contents
- Preface Material
- Product Certifications
- Company Certification
- Introduction to the MA-860 System
- Element Descriptions
- Infrastructure Preparation
- Installation
- Power-up and Provisioning the Unit
- Appendix
Appendix
MA-860 Installation and Configuration Guide 48
6.1.1.1
6.1.1.2 Tech Support Tab for MA Service Personnel
There are two Tech Support tabs designated for maintenance procedures for MA service
personnel:
• TechSupport I – displays antenna current and voltage values and provides options for
resetting the power dedtector.
6.1.2 IP Configuration Procedure
MA 850A units connected to the network may be assigned either dynamic IP Addresses through
DHCP or static IP addresses (for networks without DHCP). The addresses may be assigned from
a single location using the Lantronix DeviceInstall application supplied with the units.
The IP configuration procedure consists of the following steps:
• Installing and launching the Lantronix DeviceInstaller application on your computer.
! Connecting to the Network, page 49
• Performing Auto-Discovery, page 49
• For networks without DHCP – Assigning a Static IP Address, page 50
• Configuring the SNMP Parameters, page 54