User's Manual
Table Of Contents
- Preface Material
- Product Certifications
- Company Certification
- Introduction to the MA-860 System
- Element Descriptions
- Infrastructure Preparation
- Installation
- Power-up and Provisioning the Unit
- Appendix
MA-860 Installation and Configuration Guide
46
A
A
p
p
p
p
e
e
n
n
d
d
i
i
x
x
6.1.1 Advanced Tab Parameters
This tab is used to:
• Configure the antennas manually and perform auto-discovery of antennas
• Perform cable adjustment for each channel
• View the power level at each antenna port and at each AP port
• Reset the MA-860 unit
Table 6-1. MA-860 Configuration Tool Window Parameter Descriptions
Window Item Description
DC Protection Used to show and configure status of voltage at each antenna port.
Voltage is automatically disabled (Off) to a port where an antenna was not detected
during auto-discovery (upon power-up and upon command from the user).
The button adjacent to each DC Prot field is used to manually disable or enable
voltage to the corresponding antenna (relevant for service personnel under
conditions where an antenna is disconnected or replaced).
Note: A label will be colored RED if the corresponding antenna was disconnected by
the unit (i.e. due to a short in the antenna).