User's Manual

Power-up and Provisioning the Unit
MA-860 Installation and Configuration Guide 39
5.3 Remote Web Management
NOTE: Be sure that there is not an open local session (section Error! Reference source
not found.) to the MA 850A unit before you attempt to open a remote session to the
same unit; otherwise, the unit may stop responding.
MA 850A whose SNMP parameters are defined may be connected to the network through an
Ethernet connection and assigned addresses either through DHCP (default setting) or static
address assignment methods. The MA 850A units may then be remotely managed from any Web
Browser by connecting to the IP Address of the specific MA 850A unit or through any Network
Operating Center (NOC) using SNMP.
Use the Remote Web management options to make configuration changes and to monitor the
unit status.
5.3.1 Login and User Levels
You may login to the MA 850A unit through any Web browser. The user levels are available:
• guest (guestpass) – monitoring options only
• admin (adminpass) – monitoring and configuration options
• TechSuport – for MA technical personnel only
NOTE: The password is case sensitive – use lower case letters.
To login to the MA 850A configuration application
1. Run a Web Browser application (i.e. Internet Explorer).
2. Enter the IP Address of the MA 850A unit. (i.e. h
ttp://192.168.10.127). The Login dialog
appears. The application version is displayed at the top of the window.