User's Manual

Power-up and Provisioning the Unit
MA-860 Installation and Configuration Guide 36
5.2.2 Provisioning Procedure
Note: Refer to Figure 5-1 and Table 6-1 for the locations and descriptions of the parameters
described in this section.
To provision the unit
1. Select the Advanced tab. The following window appears.
Figure
5-1. MA-860 Advanced Tab
2. Click the Discovery All button, to discover all the antennas.
Note: To discover changes from the last Discovery All operation, click the Discovery Part button.
3. In the DC Prot field of each channel to which an antenna is connected, verify that the DC
Prot parameter is ON.
Note: If OFF is displayed in RED, it indicates the antenna is disconnected by the system (due to a
detected fault such as a short.)
4. Perform 802.11a cable adjustments as follows:
• Set up a Constant Wave signal generator to 5.745GHz at 17dBm (for optimum
results).
Step 2. Click to
discove
r
connected
antennas
Step 3. ON
Step 4. Setup
and click.
Step 5. Setup
and click.
Step 6. Review
Alarms
Step 1 Invoke
Advanced tab