User's Manual
Table Of Contents
- Preface Material
- Product Certifications
- Company Certification
- Introduction to the MA-860 System
- Element Descriptions
- Infrastructure Preparation
- Installation
- Power-up and Provisioning the Unit
- Appendix
Installation
MA-860 Installation and Configuration Guide 25
7. Connect the MA 1000 antenna ports and the MA-860 Mobile Services ports using the
four SMA to N-type cables
supplied in the accessory kit
.
NOTE: Be sure the connectors are closed at a 45 degree angle so as not to place stress on the cables.
8. Connect the power. It is recommended to use the following power supply for local power
configuration, where p
ower can also be supplied using remote power supply configurations
:
• Dedicated power supply (i.e. LPS-48-100W which feeds both modules). Refer to the
Power Supplies Manual.
9. Connect the coax antenna cables to the MA-860 unit antenna ports on the MA-860 front
panel according to the following instructions:
• Use 50 Ω, N-type male to male, 1/2” or 3/8” Plenum coax cables
• Max cable length (typically): 150’
10. Fit 50 ohm terminators on all unconnected SMA, AP and antenna ports.
MA-860
MA 1000 RHU
Power
Antenna connections
N-type SMA
j
umpers (included)