User's Manual

Remote - Web Browser Session
MA 850 Installation and Configuration Guide 36
4.2.1.5 Configuring Serial Parameters
This section describes how to verify and configure the serial communication parameters for each
MA 850 unit.
1. From the DeviceInstaller Main window, select the MA 850 unit to be configured and click
the Configure button the toolbar. The Configure Device dialog appears.
Figure 4-12. Current Serial Port Parameters
2. Click the Ports tab and then the Edit Settings… button. The Port Properties dialog
appears.
Figure 4-13. Port Properties
3. Set the parameters as follows: Baud Rate 19200, Data Bits 8, Parity None, Stop Bits 1, Flow
Control None; then, click OK. The DeviceInstaller Main window appears.