User's Manual

Remote - Web Browser Session
MA 850 Installation and Configuration Guide 34
Figure 4-10. Finish Static IP Address Definition
6. Click Finish. The Device Installer Main window reappears and the
installed unit will be listed in the window.
What next?
Define the SNMP parameters according to Configuring the SNMP Parameters, page 34.
4.2.1.4 Configuring the SNMP Parameters
Configure the SNMP Community and Trap destination addresses according to the instructions in
this section.
NOTE: The required communication parameters are pre-set for each MA 850 unit. However if
you do not succeed in connecting to the Telnet application, verify the serial communication
parameter page 36 section 4.2.1.5
1. Select the MA 850 unit which will be configured (may be identified
according to its MAC address value) and click the Telnet button in the
toolbar.
The Telnet dialog shows the IP address of the currently connected MA 850 unit.
Figure 4-11. Telnet IP Address window