User's Manual

Setup and Adjustment Procedure
Configuring MA 430 Controller Network Parameters
MA 2000 Installation and Configuration Guide 59
3. Reset the MA 430 controller by removing and reinserting the power connector on the
controller rear panel. The terminal application will be initialized.
4. Press any key within 5 sec in order to access the CLI command prompt.
5. At the password prompt, enter the default password “MA” and change the password if
desired.
6. Respond to the IP Address prompts by entering the IP Address, Subnet mask and Default
Gateway address for the MA 430 to which you are connected.
7. Respond to the Community name prompts, make any necessary changes (default Get =
Public, default Set = Private).
8. Respond to the Boot Operation prompt by selecting 2: RUN.
9. Remove the RS232 connection.
10. Connect the MA 430 rear panel COM connector to the network.
Figure 5-2. Defining IP Address Parameters