User's Manual

System Installation
2000 Lite Installation and Connections
MA 2000 Installation and Configuration Guide 55
4.4.1 Mounting MA 2000 Lite
In order to mount MA 2000 Lite on the wall, the cover is first removed, the tray and all installed
elements are secured to the wall and the top cover assembled again.
1. Remove the top cover by pulling it towards the rear bracket and lifting it over the front
brackets. The tray and all its assembled components is displayed. The installed filters vary
depending on the RU models in the installation.
Figure 4-12. MA 2000 Lite Prepared for Mounting
2. Depending on the tools you use:
Either measure the distance between the four wall mount holes and drill the required
holes in the wall and insert the screws, or
Hold the tray up against the wall and simply drill the screws in the holes.
3. Re-assemble the 2000 Lite top cover.
4. Mount each RU 2000 on the wall, on the corresponding side of the MA 2000 Lite unit.
Combiner connections
to RU RF Antenna ports
Combiner connections
to RU RF Antenna ports
Rear bracket
Digital module to RU
front panel RS232 port
Digital module to RU
front panel RS232 port