User's Manual
Table Of Contents
- 1 Introduction to the MA 1000 System
- 1.1 About MobileAccess™ 1000
- 1.2 System Architecture
- 1.3 Configuration Options
- 1.4 MA 410/430 Remote Management
- 2 System Elements
- 3 Site Preparation
- 4 System Installation
- 5 Appendix: System Specifications
System Installation
4.3.2.1 Assembly and Connections
Refer to Figure 19.
ATTENTION
To prevent damaging the SMA connectors,
be sure to tighten using a torque of 8lb.
1. Position the supplied bracket on the RHU 1000 and secure the bracket to the RHU 1000
using the four supplied 6-32 NC screws.
2. Position the RHU 1200 unit on the bracket and secure the RHU 1200 to the bracket using
the four supplied 8-32 screws.
3. Interconnect the RHU 1000 and RHU 1200 SMA Uplink, Downlink and High connectors
on the rear panels of both units using the three straight jumpers.
4. Interconnect the RHU 1000 and RHU 1200 D-type 9-pin connectors on the rear panels of
both units using the supplied flat-cable.
5. Connect the power to the RHU 1200 front-panel DC connector.6.
Figure 19. RHU 1200 to RHU 1000 Assembly
MA 1000M Installation and Configuration Guide 27