Installation Guide

Litenna  Installation Guide Appendix A Link Measurements Form
Foxcom Wireless Proprietary Information Document No.
42-93-005-23D
45
Appendix A Link Measurements Form
To smoothly carry out link measurements, use the table appears below. All relevant
parameters are listed. This table aids system evaluation and provides necessary feedback to
Foxcom Wireless.
The following issues should be taken into account:
• Measure the optical power for every link with an optical meter and light source, according
to the number of links or RHUs.
• Measure the typical signal strength (RSSI) for every installed antennas.
• Check coax cable connection between RHU and every installed antenna.
Table 9 - Link Measurement Table
System
Link
Power
Meter
(mW)
RSSI (dBm) Coax Cable (OK/Fail)
Ant1 Ant2 Ant3 Ant4 Ant1 Ant2 Ant3 Ant4
RHU1
RHU2
RHU3
RHU4
•
•
•
•
•
•
Return this form to Foxcom Wireless (fax: [phone]).