Installation Guide

Final Test Litenna  Installation Guide
42 Document No.
42-93-005-23D
Foxcom Wireless Proprietary Information
Final Test
The following checklist should be consulted when reviewing the system’s setup.
✔ Check power supplies.
✔ Check that all LEDs are lit.
✔ Carry out Walk Test, checking all antenna locations, and checking the RSSI power levels
at those locations.
Base Unit and Remote Hub Unit Connections
When the Litenna
TM
is being installed the LEDs on the units can verify that the optical
fibers are performing correctly, and that proper connections have been made.
Foxcom Wireless recommends checking the status of all connections in the Litenna
TM
system in order to make sure that the installation was carried out correctly. Verification
is done by checking the LEDs on the Base and Remote Hub Units. See Table 8 for an
explanation of the possible optical LED performance states and how to deal with
problems.
Note
When the RHU not receiving light signal from Base Unit, power to laser is

disconnected.
