Installation Guide

Litenna  Installation Guide Required Equipment
Foxcom Wireless Proprietary Information Document No. 42-93-005-23D 15
Required Equipment
The following describes the equipment required for testing the system at setup.
Table 2 – Required Equipment List
Required Setup Equipment Quantity
HP8753C Network Analyzer or equivalent 1
HP85046A S Parameter test set or equivalent 1
HP8594E Spectrum Analyzer or equivalent 1
Power supply 18/48 @ 1A 1
Signal generator HP8648B or equivalent 2
Amplifier Mini-circuit ZKL-2 or equivalent 1
Digital Multi-meter 1
RF Combiner Mini-Circuit ZAPD-21 or equivalent with
N connectors 1
High-grade 50-ohm phase matched cables:
N to N cables
N to SMA cables (in N remote type)
SMA to SMA cables (in SMA remote type)
4
2
3
Optical power meter (1310 nm) for minimum 3 mW 1
Singlemode duplex fiberoptic cable with SC/APC
connectors
3m
Singlemode fiberoptic cable SC/APC connectors 3m
Calibration kit, including
Through (N-female to N-female)
Short (N-female)
50 ohm (N-female)