User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 6
Draft
Standards and Certifications
Corning Optical Communications products have met the approvals of the following certifying organizations:
Company Certification
ISO 9001: 2000 and ISO 13485: 2003
Product Certification
US
Radio Equipment and Systems
• FCC 47 CFR part 22 – for CELL Frequency Band
• FCC 47 CFR part 24 – for PCS Frequency Band
• FCC 47 CFR part 27 – for LTE and AWS Frequency Bands
EMC
• FCC CFR part 15 Subpart B
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Warning!
Changes or modifications to this equipment not expressly approved by Corning Mobile Access could void the
user’s authority to operate the equipment.
Europe
Radio Equipment and Systems
• EN 301502 – for GSM/EGSM Frequency Bands
• EN 300609 – for DCS Frequency Bands
• EN 301908 – for UMTS Frequency Band
EMC
• EN 301 489
Licensee Contact Information
Industrial Boosters may only be used by FCC licensees or those given express (individualized) consent of license. Corning
certifies all of the VARs listed as licensed installers for Corning. For the list of licensed VARs, please contact the Corning
Tech Support Hotline: (US) 410-553-2086 or 800-787-1266.