User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 54
RF Parameters per High-Band Service
HX RF Parameters
DCS
1800 MHZ
AWS3
CDMA/WCDMA
1700 MHZ
PCS
CDMA/WCDMA
1900 MHz
UMTS
2100 MHz
DL
UL
DL
UL
DL
UL
DL
UL
Max Output Power Per Antenna Port
1 Operator (Composite) 32 33 33 29
2 Operators 29 30 30 26
4 Operators 26 27 27 23
8 Operators 23 24 24 20
Mean Gain (dB)
1
32 16 33 11 33 11 33 16
Pin (dBm) 0 0 0 0
Input IP3 (dBm) AGC OFF Typical -10 -10 -10 -10
Max Intermod Distortion (dBm) -30*
-13*
-13*
13*
NF (dB) at Max Gain 7
7
7 7
Gain Flatness/Ripple (dB)
2
+/- 2.0
Max. Noise Level 44
* WCDMA compiles with 3GPP TS 25.106 V5.0.0 (2002-03) table 9.4 spectrum emission mask.
** Out of band and spurious emissions compliant to FCC.
1
Factory set mean gain BU/OCH-HX without RIU. May be field adjusted using controller system.
2
Gain Flatness/Ripple is specified for the non-duplexed port of the system.
Coupling Specifications*
Frequency (MHz)
Coupling (dB)
Frequency (MHz)
Coupling (dB)
700 -48.0 2100 -39.0
800 -47.1 2200 -38.5
900 -46.1 2500 -37.4
1000 -45.0 2600 -37.0
1700 -40.7 2700 -36.7
1800 -40.1
1900 -39.7
2000 -40.7
*Coupling specifications are only relevant to HX models with integrated Test Ports (refer to ordering information section of this Specifications Sheet)