User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 42
4.5 Mounting
4.5.1 Wall Mount Installation
Note the following:
• The wall-mount instructions provided in this section reference installations on concrete/ solid block /brick walls.
• The brackets required for mounting the unit on the wall are integrated in to the rear panel – no required assembly.
To wall-mount the HX Outdoor Remote Unit
1. Select the wall mount location according to the following criteria:
• General surroundings
• Shielded, ventilated, and easy-to-reach area (for maintenance and on-site inspection)
• Proximity to the antenna in order to minimize cable loss
Bracket Holes for Wall Mount
Figure 4-3