User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 41
HX Outdoor Bracket Dimensions
Figure 4-2
4.4 Required/Recommended Tools and Materials for Wall Mount
Installation
• Expanding lead shield anchors with 3/8” lag bolt with hex head bolts should be used.
• Hex bolts need to be at least 3” in length
• Hex heads on bolts need to be >12.7 mm and <24.70 mm to fit bracket key-holes
• Recommended Anchor is Powers 3/8” Long lag shield with 3/8” X 3” HDG or SS Lag bolt or similar
• Kobalt 3/8-in Drive Click 20 Ft-lbs - 100 Ft-lbs Torch Wrench Model #85601 or similar
• Kobalt Crows foot wrench
• Kobalt ratching wrench
• M18™ Cordless Lithium-Ion High-Performance ½” Hammer Drill/Driver