User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 34
3.3.2 Ground Connection
• AC Cabinets - Mandatory
• DC Cabinets - Recommended
Connect the HX cabinet to the main grounding point in the rack via the terminal stud located on the rear of the unit
(ground wire with terminal not supplied).
Grounding Bolt Location – HX Rear
Figure 3-8
3.3.3 Power Connections
The power supply connections depend on the HX model (AC or DC). Each type of model is supplied with corresponding
power cable.
Power Consumption for HX Indoor models:
• SISO: 340 W
• MIMO: 500 W
3.3.3.1 AC Models
Connect the supplied AC power cable to the HX AC power connector (100/240 VAC; 50/60 Hz; 8A Slow Blow Fuse) and to
the power source See Figure
3-9 for AC connector.
AC Connector
Figure 3-9