User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 28
3.2 Mounting
The HX Indoor unit is installed in the communication room via one of the following options (each type of installation requires
a different pair of brackets -both types supplied):
• Rack-mount
• Wall-mount (requires two people)
3.2.1 General Instructions
• Indoor type HX Remote Units should be installed in a communication room that provides access only to authorized
personnel. The units are maintenance free. In the event of failure, only authorized personnel should handle the units.
• Environmental Data - Maximum ambient operating temperature: 50° C
• Maximum ambient temperature in a rack: 45° C
3.2.2 Rack Mount Installation
Rack Installation General Safety Instructions
Review the following guidelines to help ensure your safety and protect the equipment from damage during the installation.
• Only trained and qualified personnel should be allowed to install or replace this equipment.
• Verify that ambient temperature of the environment does not exceed 50°C (122°F)
• To maintain a low center of gravity, ensure that heavier equipment is installed near the bottom of the rack and load the
rack from the bottom to the top.
• Ensure that adequate airflow and ventilation within the rack and around the installed components so that the safety of
the equipment is not compromised.