User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 HX Indoor Physical Installation
- 4 HX Outdoor Physical Installation
- 5 Appendix A: System Specifications
- 6 Appendix B: Ordering Information
- 7 Appendix C: HX Outdoor Non-Standard Connector Descriptions
- 8 Appendix D: Power Cable Specifications
Corning Optical Communications User Manual I CMA-066-AEN I Page 16
1.4 System Monitoring and Management
The HX Remote Unit is centrally managed via the SC-450 Controller. Note that HX is not connected directly to the
controller. It is connected to the optical converter (i.e. BU or OCH-HX), connected to the controller. Thus, the controller
monitors views and manages the HX via the optical converter module to which the HX is connected.
The following shows the Config(uration) tabs of the selected HX unit. Refer to the SC-450 Controller User Manual for
information on how to configure and manage the HX (Indoor/Outdoor) unit.
Example of HX Configuration Tab
Figure 1-6