User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
Appendix A: System Specifications
CMA-318-AEN
Page 51
Appendix A: System Specifications
RF Parameters
Supported Services
Frequency Range
Technologies
Band
Uplink Downlink
LTE* 2300 LTE2300 2305 - 2315 MHz 2350 – 2360 MHz
* LTE compiles with 3GPP TS 36.106 V10.6.0 (2012-12) table 9.1 unwanted emission.
RF Parameters per Service Antenna Port
LTE2300 MHz
RF Parameters DL UL
Max Output Power Per Antenna
Port
1 Operator (Composite)
3
(dBm)
33
2 Operators (dBm)
30
4 Operators (dBm) 27
8 Operators (dBm) 24
Mean Gain (dB)
1
33
31
Pin
1
(dBm) 0
Input IP3 (dBm) AGC OFF Typical -15
Max. Intermod Distortion (dBm) -13
NF (dB) Typical
6
RF Output Port Impedance 50 ohm
Gain Flatness/Ripple (dB)
2
+/- 1.5
1
Factory set mean gain BU without RIU. May be field adjusted using controller system.
2
Gain Flatness/Ripple is specified for the non-duplexed port of the system.