User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 47
4. Open cabinet door to access HX WCS module(s) with the fiber optic interface, route the DL and UL fibers
through the front door slot and (see Figure 3-17) and connect as follows:
• Optic fiber connections to/from headend (BU):
o Downlink: Connect the fiber optic cable pigtails from splice box, leading from the BU port, to the
corresponding HX WCS module “From HE” SC APC optic port (MIMO models include two service
modules with fiber connections).
o Uplink: Connect the fiber optic cable pigtails from splice box, which comes from the HX WCS service
module(s), “From HE” SC APC uplink port to the BU.
• Using fiber optic jumpers, connect the HX WCS module “To RU” SC APC optic to the SC APC optic port of
the MA1000/MA2000 remote unit.
IMPORTANT! Keep in mind the rules for handling and connecting F/O cables.
Example of HX WCS Fiber optic Connections to BU and MA2000 Remote Indoor Connections
(MIMO)
Figure 3-25