User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 42
1.17 Connections
Note that the HX WCS is an upgrade unit and as such the RF and fiber connections also interface the existing
MA1000/MA2000 remote units. Where relevant, the RF and fiber connections reference existing HX and MA2000
QX as examples of connections to existing remotes.
1.17.1 RF and Fiber Connections
1.17.1.1 Installations with Additional HX Unit
1. Connect the HX WCS MUX “WB RU” 4.3-10 Type duplexed RF port to the HX duplexed antenna port.
Note: For SISO installations the connections are from HX WCS ‘ANT. 1 MUX to HX ‘ANTENNA PORT 1’; For
MIMO installations additional connections are performed between HX WCS ‘ANT. 2 MUX’ to HX ‘ANTENNA
PORT 2.
RF Connections Between HX WCS and Existing HX (Left-SISO; Right – MIMO) Figure 3-20