User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 34
3. Place the EPM onto the top of the HX WCS unit and using six UNC 6-32, 11mm screws, assemble the
EPM onto the top sides of the HX WCS unit for top side. See Figure 3-4.
Assembling EPM onto HX WCS Figure 3-12
1.16.3.2 Horizontal Wall Mount Installation
Additional required tools and materials
• Philips/electric screwdriver
• Four anchors for mounting brackets on wall (anchor type depends on surface type)
To mount the HX WCS unit on the wall:
1. Remove the factory assembled rack brackets from the sides of the HX WCS unit.
2. Using ten UNC 6-32, 11 mm screws for each bracket (provided in HX kit), assemble the wall-mount
brackets to the sides of the HX WCS as shown in Figure 3-5.