User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 33
1.16.3 Wall-Mount Installation
IMPORTANT! The wall-mount installation procedures in this section are for concrete/brick walls. For other wall
types, installer is responsible for following standard practices using the appropriate tools and materials.
The following sections provide instructions for both vertical (“belly-to-wall”) and horizontal (optional “back-to wall”)
wall-mount installation types.
Note the following:
• If the HX WCS is to be installed in conjunction with the EPM, the latter must be assembled to the HX unit
before mounting the HX on the wall. Refer to 3.2.3.1.
• When selecting the installation location, make sure that there is enough clearance distance from the bottom
to open the HX WCS chassis door.
1.16.3.1 Assembling EPM to HX WCS (for Configurations with EPM)
To assemble EPM onto HX WCS
1. Remove the factory assembled rack ears from the sides of the unit.
2. Fixed hole is at the top of the EPM unit for wall mounting. See Figure 3-3.
Assembling Brackets to EPM Figure 3-11