User Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Notwithstanding the foregoing, Corning shall have no obligation under the Software Warranty if the
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1.1 Key Features and Capabilities
- 1.2 System Architecture
- 1.3 System Monitoring and Management
- 1.4 HX Unit Description
- 1.5 External Passive Module (EPM)
- 1.6 Site Considerations
- 1.7 Environmental
- 1.8 Installation Requirements
- 1.9 Fiber Optic Requirements
- 1.10 RF Coaxial Cable Guidelines
- 1.11 Antenna Specifications and Guidelines
- 1.12 Grounding Requirement
- 1.13 Manual Handling
- 1.14 Installation Requirements
- 1.15 Unpacking and Inspection
- 1.16 Mounting
- 1.17 Connections
- 1.18 Verifying Normal Operation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Parameters for Diplexer External Input Port
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
- MobileAccessHX WCS Remote Units
오류! 지정한 스타일은 사용되지 않습니다.
CMA-TBD-AEN
Page 31
1.16.2.2 Mounting HX WCS in 19-in Rack
Note the following:
• The HX WCS requires 4U rack height availability
• If the HX WCS unit is to be installed with an existing MA1000/MA2000 remote the EPM (1U) should be
installed in between the remote units in order to facilitate the connections
• Rack nuts and screws not provided (depend on rack type)
To mount the HX WCS in a 19-in rack:
1. Determine the location of the HX WCS in the rack.
2. Secure the unit to the communication racks’ vertical uprights via at least two bracket holes on each side
(one top and one middle) using the appropriate rack nuts and screws.
Refer to Figure 3-1 and Figure 3-3 for examples of rack installations.
Examples of HX WCS Rack Installations with Additional HX and MA2000 QX Remote Units
Figure 3-9